Expert ac repair in Red Bank, SC. NATE-certified technicians, quality equipment, and results you can count on.
KIC Refrigeration delivers expert air conditioning repair in Red Bank, SC, diagnosing compressor failures, refrigerant leaks, frozen evaporator coils, and electrical faults using superheat, subcooling, and amp draw measurements. Our EPA Section 608 certified technicians restore rated SEER output through manufacturer-guided repair procedures across all major AC brands.
With a population of 11,258, Red Bank is home to thousands of properties that depend on reliable heating and cooling. Our ac repair team in Red Bank, SC combines local climate knowledge with NATE-certified expertise to deliver results that restore comfort and improve efficiency. Every project begins with a thorough system evaluation so we can recommend the right solution for your specific situation.
When you choose KIC Refrigeration for ac repair in Red Bank, you get a team that shows up on time, diagnoses accurately, and treats your property with respect. We handle all the details — from equipment selection and permits to final commissioning and warranty registration — so you can focus on staying comfortable.
Our proven process ensures your ac repair project is done right the first time.
KIC Refrigeration begins every AC repair in Red Bank, SC with a systematic assessment. We verify 24-volt control voltage at the thermostat, check high and low voltage wiring for damage, inspect the disconnect for burned contacts, confirm the breaker is properly sized, and visually inspect both indoor and outdoor units before powering up the system for testing.
At your Red Bank property, our technician tests the run and start capacitors with a capacitance meter, checks the contactor for pitting and voltage drop, measures compressor amperage against rated load amps, and reads suction and discharge pressures to calculate superheat and subcooling against the manufacturer charge chart for current conditions.
We replace the failed component — capacitor, contactor, fan motor, compressor, or metering device — using parts rated for your system. For refrigerant leaks, we locate the leak, repair or replace the leaking component, evacuate, and recharge the system by weight.
KIC Refrigeration verifies every AC repair in Red Bank, SC with a comprehensive performance test. We confirm temperature split, superheat, subcooling, compressor amperage, condenser fan amperage, blower CFM, and thermostat operation. We document all readings and explain the results before we consider the job complete.
Everything you need to know before scheduling ac repair for your property.
AC repair in Red Bank typically costs $150 to $500 for common component failures including run capacitors ($150 to $250), contactors ($150 to $350), condenser fan motors ($250 to $500), and blower motors ($300 to $600). Compressor replacement is the most expensive repair at $1,500 to $3,500 depending on unit tonnage and whether the system uses R-410A or older R-22 refrigerant. Evaporator coil replacement runs $800 to $2,500 including the refrigerant recovery and recharge. KIC Refrigeration provides a detailed written estimate with itemized parts and labor costs before beginning any AC repair at your Red Bank property so there are no surprises on the invoice.
AC refrigerant recharge in Red Bank costs $200 to $500 for R-410A systems at roughly $50 to $80 per pound, and $400 to $1,200 for older R-22 systems at $80 to $150 per pound due to the phaseout-driven supply shortage. However, simply adding refrigerant without finding the leak is a temporary and wasteful fix — the charge will leak out again in weeks or months and you will be back in the same situation. KIC Refrigeration always locates the leak first using electronic leak detectors and UV dye, repairs the leaking component, evacuates the system to remove moisture and air, and recharges by weight to the manufacturer specification. This approach fixes the problem permanently.
An AC that repeatedly trips the circuit breaker is a safety issue that should not be ignored or reset repeatedly. The most common causes are a shorted compressor winding drawing excessive amperage, a failing run capacitor that cannot provide the boost needed for compressor startup, a locked rotor condition from a mechanically seized compressor, a ground fault from damaged wiring or a grounded compressor motor, or an undersized breaker that cannot handle the inrush current. Each reset on a breaker weakens it over time. KIC Refrigeration performs thorough electrical diagnostics at your Red Bank property — including megohm resistance testing on compressor windings and amperage measurements — to identify the root cause and repair it safely.
KIC Refrigeration repairs every major air conditioning brand installed in Red Bank homes and commercial properties — Carrier, Trane, Lennox, Rheem, Goodman, Daikin, York, Bryant, Amana, Ruud, Heil, and all other manufacturers. Our technicians hold EPA Section 608 Universal certification for refrigerant handling and are trained to work with R-410A, R-22, R-32, R-454B, and all other regulated refrigerants found in residential and light commercial systems. Whether your AC is a 2-ton window package unit or a 5-ton split system, a 20-year-old R-22 unit or a brand-new inverter model, KIC Refrigeration has the diagnostic capability and parts access to repair it correctly at your Red Bank property.
What our customers say about working with our HVAC team.
"Mini split installation went smoothly. Clean work, no mess left behind. Would have liked a bit more explanation on the maintenance schedule but overall very happy."
"KIC Refrigeration did a full HVAC inspection before we closed on our new house. Very detailed report and the inspector answered all my questions patiently."
"Heat pump tune-up went fine. Technician was a bit late but called ahead to let me know. The actual service was thorough and professional."